images

This is the only cruise control that will work with the high performance motors of street rods and sport trucks. This advanced electric cruise control uses solid state electronics for exceptional accuracy and reliability. It requires no vacuum and will work with radical camshafts and blown motors. Small and quiet enough to hide under any dash. A simple wiring harness and a built in self-diagnostic check makes for exceptionally easy installation. Add the safety and convenience of cruise control to your vehicle today. 36 month / 36,000 mile warranty.

For vehicles with cable driven speedometers - includes electric servo, mounting hardware, wiring harness, electric speed sensor, and choice of control handle. Speed sensor attaches in-line with speedometer cable.

CRS-2000...................$250.00

For vehicles with electric speedometers, or for use with Dakota Digital instruments - Includes electric servo, mounting hardware, wiring harness, and choice of control handle. Compatible with 2K, 4K, and 8K pulse per mile speed signals. (Dakota Digital instruments use 8K ppm signals).
CRS3000..................$215.00

ALUMINUM COVER FOR HND-1, HND-3, HND-4, AND HND-7.

Polished aluminum finish HNC-1-P..................................$32.00

Brushed aluminum finish HNC-1.......................................$30.00

Braided cable replaces black plastic cable in cruise control kits. Cables are “U-Cut-T0-Fit” inside and outside of firewall.

Braided cruise cable for carbureted engines LOK-1601....$62.50
Braided cable for Tune port Injected engines LOK-1603...$62.50

Each CRUISE CONTROL is supplied with choice of the following control handles. Several other handles available. Call for your special applications not listed here.

UNIVERSAL CUTOFF HANDLE - Secures to existing turn signal handle shaft.........HND-1

DASH MOUNT SWITCH - Can be secured to or under dash for hidden operation...HND-2
REPLACEMENT GM HANDLE - Secures with single screw through flat end.............HND-3

GM “PUSH IN” HANDLE - For most post ‘80 GM columns. No wiper controls...........HND-4

GM “PUSH IN” HANDLE - For most post ‘80 GM columns. Wiper equipped..............HND-5

GM “PUSH IN” HANDLE - For most post ‘80 GM columns. Wiper w/delay..................HND-6

FORD “SCREW IN” HANDLE - Ford ‘83 and earlier.........................................................HND-7